Bill Text: NJ S309 | 2012-2013 | Regular Session | Introduced
Bill Title: Requires school districts to provide for the safe operation of electrically operated partitions in classrooms or other school facilities.
Spectrum: Bipartisan Bill
Status: (Introduced - Dead) 2012-01-10 - Introduced in the Senate, Referred to Senate Education Committee [S309 Detail]
Download: New_Jersey-2012-S309-Introduced.html
STATE OF NEW JERSEY
215th LEGISLATURE
PRE-FILED FOR INTRODUCTION IN THE 2012 SESSION
Sponsored by:
Senator JIM WHELAN
District 2 (Atlantic)
Senator CHRISTOPHER "KIP" BATEMAN
District 16 (Hunterdon, Mercer, Middlesex and Somerset)
Co-Sponsored by:
Senator Beach
SYNOPSIS
Requires school districts to provide for the safe operation of electrically operated partitions in classrooms or other school facilities.
CURRENT VERSION OF TEXT
Introduced Pending Technical Review by Legislative Counsel
An Act concerning electrically operated partitions in school districts and supplementing chapter 20 of Title 18A of the New Jersey Statutes.
Be It Enacted by the Senate and General Assembly of the State of New Jersey:
1. As used in this act, "electrically operated partition" means any partition, room divider, curtain, or other similar device which is controlled through the operation of an electrical motor.
2. a. Except as otherwise provided in subsection b. of this section, the board of education of a school district in which classrooms or other facilities used by students have electrically operated partitions shall ensure that:
(1) every electrically operated partition is equipped with two key-operated, tamper-proof, constant pressure control stations that are remotely located at opposite ends and opposite sides of, and in view of, the partition, and which are designed and constructed to require simultaneous activation of both control stations to operate the partition;
(2) the electric device controlling the operation of the partition is capable of being reversed at any point in the extend or stack travel cycle; and
(3) devices are provided for all partitions that will stop the forward or backward motion of the partition and stop the stacking motion of the partition when a body or object passes between the leading panel of the partition and a wall or other termination point, or when a body or object is in the stacking area of the partition.
b. The Commissioner of Education shall excuse a board of education from compliance with the provisions of subsection a. of this section upon submission of a written certification, in a form prescribed by the commissioner, certifying that the school district is unable to fully comply with the provisions of subsection a. of this section and that the school district will adhere to the following procedures until compliance may be achieved:
(1) the partition will not be operated during normal school hours;
(2) the partition will not be operated when there are students or other individuals, other than the required operators, present in the space being divided;
(3) the partition will be operated only by individuals who are properly trained in the safe operation of the partition; and
(4) appropriate signage stating the requirements of this subsection will be posted adjacent to each partition operating mechanism.
3. The board of education of a school district in which classrooms or other facilities used by students have electrically operated partitions shall ensure that:
a. Appropriate and conspicuous notice regarding the safe and proper operation and supervision of the partition is posted in the immediate vicinity of the partition, on both sides of the separation and adjacent to the operating mechanism;
b. A procedure is established for the notification of all school employees and all other persons who regularly make use of the area in which the partition is located of the safe and proper procedure for the operation of the partition. Staff shall be trained in the safe operation of the partition. The training shall include a discussion of any past accidents involving partitions in the school district and the potential for serious injury or death when the partitions are not operated in a safe and appropriate manner. The school district shall maintain records of the training which has been provided;
c. Students shall not be permitted to operate the partition. If the school district is in compliance with the provisions of subsection a. of section 2 of this act, individuals other than the required operators may be present while the partition is being operated. Any students present while the partition is being operated shall be under the direct supervision of trained staff and shall be required to stand away from, and not be allowed to cross the path of, the moving partition; and
d. Safety features shall not be tampered with, overridden, or by-passed. All equipment shall be maintained in accordance with the manufacturer's instructions, including the manufacturer's recommended service interval, and records of maintenance shall be maintained by the district. All equipment shall be installed in a fail-safe manner so that the failure of any safety device renders the electrically operated partition inoperable until the device is repaired.
4. A school district shall report annually to the Commissioner of Education any incidences in which an electrically operated partition malfunctioned and caused a person to sustain injuries.
5. This act shall take effect one year following the date of enactment.
STATEMENT
This bill concerns the safe operation of electrically operated partitions in school districts. "Electrically operated partitions" are defined as partitions, room dividers, curtains or other similar devices which are controlled through the operation of electrical motors. The bill would require a board of education of a school district in which classrooms or other facilities used by students have these partitions to ensure that:
(1) every partition is equipped with two key-operated, tamper-proof, control stations that are located at opposite ends and opposite sides of, and in view of, the partition, and which are designed and constructed to require simultaneous activation of both control stations to operate the partition;
(2) the electric device controlling the operation of the partition is capable of being reversed at any point in the extend or stack travel cycle; and
(3) devices are provided for all partitions that will stop the forward or backward motion of the partition and stop the stacking motion of the partition when an object passes between the leading panel of the partition and a termination point, or when an object is in the stacking area of the partition.
A board of education will be excused from compliance with the requirements set forth above, upon submission to the Commissioner of Education of a written certification that it is unable to comply with the requirements, and that it will follow certain specified procedures until compliance may be achieved. Those procedures include not permitting the partition to be operated during normal school hours and not operating the partition when there are individuals other than the required operator present in the space being divided.
The bill would also require the board of education to ensure that:
· Notice regarding the safe and proper operation and supervision of the partition will be posted in the immediate vicinity of the partition;
· A procedure is established for the notification of all school employees and all other persons who regularly make use of the area in which the partition is located of the safe and proper procedure for the operation of the partition. Staff will also be trained in the safe operation of the partition;
· Students will not be permitted to operate the partition. In the case in which the school district is in compliance with the safety devise requirements for the partition, students may be present while the partition is being operated but they will be required to be under the direct supervision of trained staff; and
· Safety features will not be tampered with and all equipment will be maintained in accordance with the manufacturer's instructions. Additionally, all equipment will be installed in a fail-safe manner so that the failure of any safety device renders the electrically operated partition inoperable until the device is repaired.
